ملتقى الفيزيائيين العرب > قسم المناهج الدراسية > فيزياء المرحلة الجامعية. | ||
بحث علمي .. رابط .. MODELLING THE EFFECTS OF DISTRIBUTED SERIES RESISTANCE ON SUNS-VO |
الملاحظات |
|
أدوات الموضوع | انواع عرض الموضوع |
#1
|
|||
|
|||
بحث علمي .. رابط .. MODELLING THE EFFECTS OF DISTRIBUTED SERIES RESISTANCE ON SUNS-VO
MODELLING THE EFFECTS OF DISTRIBUTED SERIES RESISTANCE ON SUNS-VOC,
http://www.zshare.net/download/79068594906aa387/ |
فيزيائي 2009 |
مشاهدة ملفه الشخصي |
البحث عن كل مشاركات فيزيائي 2009 |
#2
|
|||
|
|||
![]() ABSTRACT
A simple model based on the simulation of distributed series resistance effects in solar cells is presented. This model overcomes limitations of the standard two-diode model representation of solar cells in respect to fitting Suns-Voc (m-Voc) and Jsc-Suns curves. The model results include (i) an improved understanding of two-dimensional current flows in shunted solar cells, (ii) the prediction of shunt types from m-Voc curves and corresponding distributed resistance model fits, (iii) the insight that lateral current flows in solar cells are responsible for deviations between Jsc-Suns data and twodiode model fits in the high illumination range. The presented approach extends the application range of Suns-Voc measurements to solar cells which cannot adequately be described with the two-diode model. |
فيزيائي 2009 |
مشاهدة ملفه الشخصي |
البحث عن كل مشاركات فيزيائي 2009 |
#3
|
|||
|
|||
![]() INTRODUCTION
The two-diode model [1-4], which aims at describing the dark and illuminated I-V characteristics of p-n junction solar cells, is widely used to extract relevant device parameters such as the light-induced current density JL, the shunt resistance Rsh, the lumped series resistance Rs and the saturation current densities J01 and J02 of the two diodes (D1 and D2) [1, 5-8]. Two-diode model fits to experimentally measured Suns-Voc [9] curves are particularly useful since metal contacts are not required and the measurements can thus be performed during early stages of the cell fabrication sequence [6, 8]. However, in many cases this standard model is not sufficient to understand the characteristics of real devices due to non-idealities and three-dimensional current flows within the cells [2, 3, 10]. In this work we use a simple distributed series resistance (DSR) model to simulate Suns-Voc, m-Voc and Jsc-Suns [7] curves. We show that the presented DSR model is able to explain deviations between measured and two-diode modelled data that are frequently observed in these measurements. |
فيزيائي 2009 |
مشاهدة ملفه الشخصي |
البحث عن كل مشاركات فيزيائي 2009 |
الذين يشاهدون محتوى الموضوع الآن : 1 ( الأعضاء 0 والزوار 1) | |
انواع عرض الموضوع |
![]() |
![]() |
![]() |
|
|